The Garage Light (Legacy) Support🔸168飞艇计划全天计划7码
Documents双赢集团下载app网址大全
Tech Specs
Warranties
Installation
FAQs双赢集团下载app网址大全
About The Garage Light (Legacy)🔸彩票带赚团队正规平台
Can I dim the light on my Garage Light?
Garage light does not come wired to be dimmed by an external wall control. However, there may be alternative methods. In this case, we recommend contacting Big Ass Fans Customer Service to discuss the options.
How many watts does Garage Light use?
Garage Light uses 122 watts, 1 amp at 120 volts.
Can I remove the 120-volt plug and directly wire my light to power?
Yes, the plug can be removed and the fixture can be hardwired as long as you follow all requirements set forth by the National Electric Code (NEC) and ANSI/NFPA, as well as any local codes. Code compliance is not the responsibility of Big Ass Fans.
What is the occupancy sensor’s range?
Optimal Detection — Under 7 feet from fixture
Good Detection — 7 feet to 11 feet from fixture
Limited Detection — 11 feet to 25 feet from fixture
Controlling The Garage Light (Legacy)🔸彩票带赚团队正规平台
Can I adjust the settings on my Garage Light occupancy sensor?
![](png/1st-and-2nd-gen-occ-sensors-1.png)
1ST GENERATION OCCUPANCY SENSOR
双赢集团下载app网址大全
TIME DELAY🔸彩票带赚团队正规平台
To change the amount of time the light stays on when the room is unoccupied, remove the sensor’s lens, and adjust the set screw labeled “Time Delay.” The delay can be set from 30 seconds (turn screw fully counterclockwise) to 30 minutes (turn screw fully clockwise).
LIGHT LEVEL🔸彩票带赚团队正规平台
To adjust the ambient light level at which the light will turn off when the space is occupied, remove the sensor’s lens, and adjust the set screw labeled “Light Level.” The light level can be set from a very dim 10 fc (foot-candles) to a very bright 120 fc. By default, the light is set to 120 fc. For most applications, we recommend leaving the light level at 120 fc.
2ND GENERATION OCCUPANCY SENSOR双赢集团下载app网址大全
This sensor comes preset from the factory to shut off ten minutes after the room is unoccupied. These settings can not be adjusted. If you have special circumstances where setting adjustments are required, please contact Big Ass Fans Customer Service at 1-877-244-3267.
Trouble with Something Else🔸彩票带赚团队正规平台
Why does my light with occupancy sensor act strangely when I first power it up?
The occupancy sensor calibrates itself whenever the power is removed and reapplied. The light may turn on for approximately 30 seconds before shutting off for approximately two minutes. During this time, the light performs the calibrations.
However, if the light was off when power was removed, the light will not turn on for the first 30 seconds; instead, it will stay off for those 30 seconds, and then remain off during the two minute calibration.
After two minutes, the light will operate normally. Because of this calibration process, we recommend not using a toggle switch for power on a light with an occupancy sensor. If possible, connect the fixture to a continuous power source and let the occupancy sensor turn the fixture on and off.
Still Need Help?🔸彩票带赚团队正规平台
Call our exceptional customer service team for help with all your fan-related questions.