ISIS Support🔸168飞艇计划全天计划7码

To start the fan, tap the upper portion of the pushpad once. The fan may take up to 30 seconds to begin rotating.

To stop the fan, tap the lower portion of the pushpad once.

To increase fan speed, press and hold the upper portion of the pushpad.

To decrease fan speed, press and hold the lower portion of the pushpad.

To disable the fan, pull out the clear tab at the bottom of the controller.

A blinking LED indicates a fault code. Big Ass Fans have built-in checks that look for both internal and external faults.

On the side of the motor there is a small opening with a red LED inside. If the fan has a fault, this LED light will blink a set number of times, then pause for four seconds. The number of times the light flashes before pausing indicates the fault. Click here for a full listing of the fault codes.

To clear a fault, turn off power to the fan at the circuit breaker for a minimum of five minutes.  After five minutes, turn the power back on and run your fan.